 |
|
| |
 |
 |
 |
|
|
|
| TMC 63-500 Series
High-Performance Lab Tables provide an excellent vibration-free
working surface for loads up to 350 lb (160 kg). Now with modular
construction, these tables are recommended for use in such diverse
applications as electrophysiology, cell injection, ultramicrotomy,
photomicroscopy, scanning tunnel microscopy, and confocal laser
scanning microscopy. |
|
 |
|
|
|
|
| |
 |
|
 |
|
|
|
| Tables may be fitted
with armrests and rigidly supported sliding side shelves just
above the table top. The sliding shelves must be used in conjunction
with a front support bar and a rear support bar that are fastened
to the table legs. The bars can be retrofitted, but cannot be
used with the full perimeter enclosure or Faraday Cage. |
|
|
|
|
|
|
| |
 |
|
 |
|
|
|
| TMC’s Active
Vibration Isolation Table features state-of-the-art vibration
isolation performance. By integrating our new Compact Sub-Hertz
Pendulum Isolation System (CSP®) for horizontal vibration
reduction with a new PEPS-VX® Inertial Damper. |
|
|
|
|
|
|
| |
 |
|
 |
|
|
|
| The Type II Faraday
Cage offers improved access and simplified assembly. The “window-shade” type
retracting front panel is easier to operate than hinged doors
and causes less disturbance when adjusted. This front panel may
be positioned anywhere between fully opened and closed and stays
in position without a fastener. |
|
|
|
|
|
|
| |
 |
|
 |
|
|
|
| For granite tops
and CleanTop® II breadboards, three isolators are adequate
for most loads. Some applications may benefit from a fourth isolator
to allow alternate isolator arrangements. The effect on isolation
is negligible. Heavier stainless steel laminate tops generally
use four isolators for better load distribution. |
|
|
|
|
|
|
| |
 |
|
 |
|
|
|
| High-Performance
Vibration Isolation System with Compact Sub-Hertz Pendulum Technology.
Lightweight system with exceptional low frequency passive vibration
isolation. |
|
|
|
|
|
|
| |
 |
|
 |
|
|
|
| Another in a long line of TMC innovations, our 75 Series Breadboards minimize both weight and cost. A patented manufacturing technique allows us to form countersunk, tapped holes in a thin top skin of stainless steel. The holes are not drilled or punched, but fabricated in a way that effectively “thickens” the skin in a small ring around the threads. No inserts are used and the tapped holes are 3 threads deep. |
|
|
|
|
|
|
| |
 
© 2006-2010 AutoMate Scientific, Inc.
|
