 |
BubbleStop™ Syringe Heater
Bubbles in perfusion systems
are caused by solution temperature changes. As solutions
warm, they cannot hold as much gas, so they off-gas. This
forms bubbles in perfusion tubing. It is especially true
in inline heaters where the temperature rises dramatically.
The best cure for bubbles is to pre-warm your solutions.
AutoMate Scientific introduces the BubbleStop™ Syringe
Heater with integrated temperature sensor and feedback. Set
the temperature on the BubbleStop a few degrees higher than
room temperature or your inline heater, and the warmed solutions
will off-gas in the syringe reservoirs to the maximum gas
concentration for that temperature. Even if they cool and
re-heat again inside the perfusion tubing, they will not
off-gas.
• Easy
to remove full syringes
• Analog heating power
- low noise for electrophysiology
• Completely
shielded electronics plus external power supply
• Spill-proof
design
• Range: ambient to 50°C liquid temperature
• Mounts
to standard 1/2" rod
|
|
 
Off-gassing with pressurized perfusion.
Note: the BubbleStop is NOT sufficient to warm solutions for delivery
into a perfusion chamber without an inline heater like our ThermoClamp.
The BubbleStop only helps stop bubbles.
|
|
