Electrode holder fits amplifiers with BNC connectors
Electrode holder fits amplifiers with BNC connectors
$150.00
Description
The new Stable-tip electrode holders eliminate the final instability link in the electrophysiology experimental setup. We’ve taken a thermally stable base material and coated it with aluminaoxide. This coating has two benefits: first, it is non-conductive so the holder does not act as an electrical antenna; second, it is very resistant to corrosion.
Under conditions of a high resistance electrode seal (gigaseal), the ST series electrode holder has a noise level of 0.79-0.80 pA RMS (5kHz filter); polycarbonate measured 0.78-0.79 pA (reported using an Axopatch 200B in whole-cell mode). The base material of the Stable-tip has a thermal expansion coefficient of 23µm/m°C versus 70µm/m°C of a polycarbonate holder. That is an improvement by a factor of three.
The Stable-tip electrode holders come with one (1) each of Ag-wires and wire seals.
NOTE: Pipette seals are not required for the latest model ST-50. When ordering, specify the headstage amplifier. If ordering for a Axon CV-4 the major diameter of the mounting feature is needed.
Specifications
• High thermal stability
• Low noise
• Versions for BNC and threaded headstage attachment
• Thermal expansion coefficient, CTE linear 68°:
Polycarbonate 70 µm/m-°C
Stable-tip 23 µm/m-°C
• Electronic noise characteristics:
Polycarbonate 0.78-0.79 pA
Stable-tip 0.79-0.80 pA
Manufacturer: Siskiyou
Catalog number: SD-ST50-BNC
Parent Category: Electrode Holders
Application: Siskiyou Mechanicals
For full web page, please see https://www.autom8.com/siskiyou-mechanicals-overview/electrode-holder
Download a brochure at https://www.autom8.com/wp-content/uploads/2016/07/Siskiyou-Accessories.pdf
Additional information
Weight | .55 lbs |
---|